VFDs or variable frequency drives are essential nowadays in industrial environments for their cost efficiency and better performance. However, firms need to spend the money only after proper analysis. A retrofit application can also be considered when the VFD is being upgraded, replaced, and in other instances. The new drives can also be installed by using the same enclosures and wirings.

[ Read More ]

Electrical equipment can be used and safely placed in the electrical enclosure, even in hazardous locations, through purge and pressurization. The purge electrical control panels, or the pressurized enclosures, are built to maintain the right pressure within their interiors, which ultimately does not allow the outside gases to penetrate the insides of the enclosure and panel.

[ Read More ]

When it comes to the matter of designing electrical enclosures intended to protect against debris and water, considering NEMA or IP standards is essential. Before initiating the design, careful consideration should be made as to what is the purpose of designing. As per the guidelines set by the control panel manufacturer, this will help in creating a better functional enclosure.

[ Read More ]

The machinery framework by control panel manufacturer states about panels consisting of power circuits which provide signals directing towards the performance of the equipment. This panel is mounted over a back panel as per the requirement of its application. Taking note of the design guide provided by the control panel manufacturer, control panel design initiates with evaluating design requirements with specifications and developing plans.

[ Read More ]

A motor enclosure should hold the motor components together and save them from damage from moisture, contaminants, abrasion, and chemicals. While the process is hazardous in itself, the presence of class 1 div 2 enclosure means that the enclosure should have proper cooling to save the motor from inflaming from gases and vapors by appropriate cooling.

[ Read More ]

We have been neglecting the importance of even power distribution on our homes, workplaces and other essential places since forever. However, it is impossible to get even a single appliance work if you have a different power distribution across the board.

[ Read More ]

The electrical control panel is an important unit that exists in domestic and commercial places. It is significant to enclose dangerous wirings and electric fittings that control the power supply in an entire designated area. In many areas, it is seen that an electrical control panel needs to upgrade due to wear and tear or least protection issues. Hence, if a property doesn’t have a suitable electrical service panel, then after up-gradation, there are some valuable benefits-

[ Read More ]

A power conversion device meant for converting fixed voltage as well as frequency to different levels of frequency is known as variable frequency drive. It is also known for controlling the speed of voltage and frequency used in power systems. However, VFD allows AC motors to operate at variable speeds.

[ Read More ]

Industrial plants have specific areas known as classified areas to install automation components. These areas are divided into zones and classes like Class 1 div 1 and Class 1 div 2 enclosures.

[ Read More ]

To ensure that any equipment keeps going, it is important to keep its components in their best shape. The industrial control panels make sure that the entire system works to its optimum.

[ Read More ]

There are a plethora of lighting control systems available today and some are also operated through the computers remotely. Cost efficiency and convenience are only some of the benefits of these new-age systems.

[ Read More ]

During the past years and decades, electronics testing equipment and technologies have improved significantly. While the noise is being reduced, aspects including data transfer, test data processing, accuracy, cooling, and others are being improved significantly, and the cost of testing has also reduced.

[ Read More ]